KP3S Pro Heatbed cable strain relief, angled
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strain relief for the KP3S Pro heatbed cable, angled at 90 degrees
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 25
- Makes
- 0
- Views
- 327
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The KP3S Pro really needs a strain relief, and the model made by LMaker is really good. It sticks out a little too far behind the bed for my use case though (my printer cabinet is very small), so I made a version that angles the cable 90 degrees towards the cantilever profile.
In order to make sure that the cable collector doesn't stick out too much towards the back either, I used a slightly longer M3 screw, with a nut in the end, for one side of the cover and tightened down the cable collector against this with a zip tie (see photo).
Printed in PLA with 0.3 mm layer height, 100% infill and later “annealed” to make it more temperature resistant (can withstand 110+ degrees C without issue).