Raspberry Pi CSI Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I somehow broke about every CSI clip on all my Pi's, and cannot find replacements. So- I decided to make my own.
- Ocena
- 4,5 / 5
- Polubienia
- 24
- Pobrania
- 603
- Wydruki
- 1
- Wyświetlenia
- 1822
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was made when I went to install a camera into Octoprint. I broke the CSI/DSI clip trying to loosen it to insert the cable. Apparently I'm the only one who manhandles these (unfortunately now) really expensive devices- and I could not find just the litttle clip that holds the cable in. I did print 4 of these at the same time, spaced out good so that they had some time to cool before the next layer went down. I also printed at 0.05, although I'm not sure that's strictly needed (apparently it works fine printed in .1 as well, thanks @lumennovum_571639). I used Overature PETG, and the clip fits into both the CSI and the DSI slots. Please make sure that your printer is dialed in well, otherwise you might just print a mess. It's a very small piece. PLA could work as well, I just prefer to print in PETG. I did test it out, it fits well and holds the cable in place.
This clip should fit all of the full sized pis- I know it will fit the 3s and the 4b, but will not fit the zero. There are a couple other MIPI CSI retainer clips over on “the other” platform for the zero, but mine was built from scratch.