Raspberry Pi CSI Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I somehow broke about every CSI clip on all my Pi's, and cannot find replacements. So- I decided to make my own.
- Rating
- 4.5 / 5
- Likes
- 24
- Downloads
- 603
- Makes
- 1
- Views
- 1,822
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was made when I went to install a camera into Octoprint. I broke the CSI/DSI clip trying to loosen it to insert the cable. Apparently I'm the only one who manhandles these (unfortunately now) really expensive devices- and I could not find just the litttle clip that holds the cable in. I did print 4 of these at the same time, spaced out good so that they had some time to cool before the next layer went down. I also printed at 0.05, although I'm not sure that's strictly needed (apparently it works fine printed in .1 as well, thanks @lumennovum_571639). I used Overature PETG, and the clip fits into both the CSI and the DSI slots. Please make sure that your printer is dialed in well, otherwise you might just print a mess. It's a very small piece. PLA could work as well, I just prefer to print in PETG. I did test it out, it fits well and holds the cable in place.
This clip should fit all of the full sized pis- I know it will fit the 3s and the 4b, but will not fit the zero. There are a couple other MIPI CSI retainer clips over on “the other” platform for the zero, but mine was built from scratch.