Combo Wrench Holder Set (Pegboard compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of four wrench holders for 13 combination wrenches. Can be mounted on 1" pitch pegboard or put in tool chest tray.
- Ocena
- 4,875 / 5
- Polubienia
- 126
- Pobrania
- 876
- Wydruki
- 8
- Wyświetlenia
- 3181
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Intro
If you're cursed enough to live in North America, you need two wrench sets. I like the ideas of having both sets arranged in some kind of symmetrical fashion on my wall as in the picture (therefore resulting on asymmetric holders). While I was at it, I also drew symmetrical versions which may look nicer in a tool chest tray, or if you have only one set to hold.
Pegboard installation
The mounting holes are separated by integer multiples of 1", in order to mount on a standard pegboard sheet. If you want to you that route, there pockets are fit for BigRedButton's anchors (see link below)
Printing instructions
I had good results (albeit quite a bit of stringing between the combs) by just printed in PETG using the default settings in Prusa Slicer with no support. The anchors pockets' ceilings are made in two steps for straight bridges.
Credits
- Inspiration https://www.printables.com/model/5724-schraubenschlusselhalter-open-end-wrench-holder.
- Pegboard anchors https://www.printables.com/model/129824-pegboard-anchor