Tri-Zero v0 Scrub Brush Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Scrubbing brush bracket to fit on to the Tri-Zero (a Voron 0 derivative).
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 63
- Wydruki
- 2
- Wyświetlenia
- 588
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Scrubbing brush bracket to fit on to the Tri-Zero (a Voron 0 derivative).
This bracket was inspired by the bigger brother variant for the Voron 2.4. I wanted a variant for the v0 that could be used without additional servos, allowing for a very automated start sequence. The macro for the original can be used with this mod fairly seemlessly.
There are 3 files for the brush mount, depending where on rear bed you would want to place the brush. I used the “right” side as I needed space to purge between the brush and zero click.
BOM: 4x M3 nuts, 4x M3x8mm BHSC, Wire Brush head removed from handle.
There wasn't much room left for a purge bucket. I found the the bottom of the Trizero acted as a decent bucket on it's own.
The Trizero has an alternate configuration under the bed, with enough room to allow for this brush, I'm sure it could be adapted to the original v0 or other mods.