RJ45 CAT6 keystone for hexagonal front skirt hole on Voron 2.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created this to have easy access to the SPI port from the outside of the printer.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 184
- Wydruki
- 1
- Wyświetlenia
- 2283
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a keystone insert for a voron 2.4 front skirt, so that an ethernet connector can give easy access to the SPI port on the controller board or the Raspberry Pi inside the printer. This is to simplify connecting an ADXL345 when necessary. On the inside, an old network cable is cut up and wired to some dupon connectors that will be plugged on the SPI header. Make a note of which color go to which. You have to replace the other end with a female RJ45 plug that will be inserted into this keystone. The other half of your cable you will solder to the ADXL345 board, making sure that the colors are connected to the same pins that they are on the dupont header (SCL to SCL, MISO to MISO, etc…)
Once you printed the model, insert it from inside the electronic bay into the hexagonal hole of your choice. Only then insert the RJ45 connector into it. The RJ45 will slightly expand the keystone and lock it into the hole. A significant amount of force should be required to insert the RJ45 jack into the keystone