Mavic Air 2 Motor Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was looking for a motor cover to protect the shaft & spring when props are removed.
- Ocena
- 4,5 / 5
- Polubienia
- 21
- Pobrania
- 196
- Wydruki
- 0
- Wyświetlenia
- 1025
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
I was looking for a motor cover to protect the shaft & spring when props are removed. Found a couple similar ones for Mavic Pro, but they are not compatible with Mavic Air 2 - so I modeled my own.
Mounts the same as the props - just push down and twist.
Modeled in Onshape, with critical dimensions derived from props and motors. STL and STEP files are attached.
Print instructions
Printed as shown in Cura screenshot with 0.2mm layers, 2 walls, and 20% infill.
Support is needed for the retention tabs, but for me they came off cleanly with a small flathead screwdriver.