Pegboard holder for Abbey HAG derailleur alignment tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hold your HAG on pegboard the most secure way that also looks great.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 445
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Holds your Abbey HAG derailleur alignment tool on pegboard the nicest way - upright. I made several alternatives but this was the only one that looked right and was actually secure.
Print both pieces, and put the top retaining clip at a height so that it holds the handle of the HAG.
Alternative
Abbey has just released their own printable designs for free on their site. Very similar to my design, but without the retaining clip - they offset the bottom of the tool so it's leaning back against the pegboard. I think mine is more secure, but of course I think mine is the best, I'm biased.
The great thing is that both of the designs are free so you can download and print both and see what you think!
Printing instructions
I usually do 0.2-0.3mm layer height with three shells, although it'll likely be plenty strong with only two.
Support is only needed for the pegs in the back, and honestly it's not crucial. I've printed this style of pegboard pegs before without supports and it just comes out a little messy on the bottom of the top pegs, which honestly helps it grip in the pegboard.
If you're printing with supports, choose supports on the build plate only and you'll get what you need. PrusaSlicer does a good job with supports and they should break right off.