Mesh Bed Leveling Z Test Pattern - 25 Points
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prints a test square at all locations of a 25 point mesh bed leveling grid. Coordinates taken from a Sovol SV06.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 735
- Wydruki
- 1
- Wyświetlenia
- 1577
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
Note that there is now a test model that also searches for the correct Z offset for each mesh point. I feel this is more useful than this model.
Designed this print to help me dial in each location in a 25 point manual mesh bed leveling grid (individual offsets can be edited). Took the coordinates from my Sovol SV06 printer, so others may vary. The squares are centered directly over the probe points. A strip connecting them all was added to make removal easier.
If using this on a SV06 with its initial priming strip on the left hand side, it'll hit some of the test squares, so replace these gcode lines:
G1 X10.1 Y20 Z0.28 F5000.0 ;Move to start position
G1 X10.1 Y200.0 Z0.28 F1500.0 E15 ;Draw the first line
G1 X10.4 Y200.0 Z0.28 F5000.0 ;Move to side a little
G1 X10.4 Y20 Z0.28 F1500.0 E30 ;Draw the second line
With these ones to get an out-of-the-way horizontal priming line instead:
G1 X20 Y35.1 Z0.28 F5000.0 ;Move to start position
G1 X200 Y35.1 Z0.28 F1500.0 E15 ;Draw the first line
G1 X200 Y35.4 Z0.28 F5000.0 ;Move to side a little
G1 X20 Y35.4 Z0.28 F1500.0 E30 ;Draw the second line