Freehub holder for Bontrager Rapid Drive (plus inadvertent fidget toy)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hold a Bontrager Rapid Drive freehub with pawls and springs and the matching endcap.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 412
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I found myself with a couple spare freehub bodies for the Bontrager Rapid Drive hubs (commonly found on Bontrager MTB wheels) so I decided to make a holder. An initial prototype worked well but without teeth it would turn both ways and this was unexpectedly disappointing, so I added teeth and now it not only holds the freehub, but became an inadvertent fidget toy. I have it sitting on my desk and play with it often during the day.
The freehub in the photos has only three pawls so it has 54 points of engagement. If you're fancy and have six in yours, this should wind up with 108 points of engagement. Just remember that this is a printed thing and sometimes it doesn't exactly engage like you might hope.
See it in action on Instagram.
May fit other freehubs but no guarantees.
Printing
Pretty straightforward, no supports, no need for strength in the way of more shells or heavier infill. Just load it up at your desired layer height (I used 0.2mm) and print it out.
The “axle” is slightly undersized but should be a light press fit for the axle endcap. If it doesn't, remember that it came out the right size on my printer so I don't want to hear how the design is defective if your printer isn't calibrated. Yes, I've heard that more than once or twice. 😆