1 / 3
Vallejo Model paint shaker
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've crated this attachment for a Jigsaw to shake my Vallejo Paints properly. Printed on an Anycubic i3 Mega
- Ocena
- 5 / 5
- Polubienia
- 44
- Pobrania
- 184
- Wydruki
- 3
- Wyświetlenia
- 2893
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 3) (Komentarze: 3)Remiksy (1)Kolekcje (63)Powiązane
I've crated this attachment for a Jigsaw to shake my Vallejo Paints properly.
Printed on an Anycubic i3 Mega (PLA 0.15mm 100%infill)
I've added screwholes for M3 Screws but mine holds super tight without
Just put the Jigsaw blade inside the hole (from bottom to top) until it is well stuck inside.
I've used a little Hammer for this.
I will upload a Video later.
