Dual linear rail mount MGN12H - Ender3pro, 3v2 and 3max (and other with 40x40 Y profile )
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual MGN12H ender3pro/v2/max (likely not for ender3 v1) Requires four M5x12 Endstop doesn't need relocation.
- Ocena
- 5 / 5
- Polubienia
- 90
- Pobrania
- 434
- Wydruki
- 2
- Wyświetlenia
- 2616
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You'll need four M5x12
and eight M3x6 for the linear rail block (M3x8 might work too, not sure)
To install it, partially screw in the screw into the hex nut (use the stock ones) to lift the nut, and place the mount over the rail block (then you can let go of the screw) and secure the rail block.
Then you can remove the M5 screws and mount the rest of the bed as normal.
The mount matches the stock wheel length so the end stop doesn't need to be moved.
you will not loose much Z, I don't remember the exact value but something like 5~10mm
------
Support me on Patreon !
https://patreon.com/squirrelf3d
(STEP file for this are on there)
or buy me a coffee
https://ko-fi.com/squirrelf3d
https://www.buymeacoffee.com/squirrelf