1 / 1
KitchenAid Artisan Tilt Knob — zdjęcie 1

KitchenAid Artisan Tilt Knob

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A replacement tilt knob for the KitchenAid Artisan mixer. Based on the original, resembles the original.

Ocena
0 / 5
Polubienia
2
Pobrania
73
Wydruki
0
Wyświetlenia
413
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Public Domain

The original tilt knob fell\broke so I made a replacement one.

This replacement is based on the original and resembles it, but is not fully 100% identical. Mainly to make printing easier without the need for supports.

This is a press\tight fit. It is meant to come on and stay there. To fit, please do the following:

  1. Use a plier to hold the tilt lever in the middle position while doing #2 and #3.
  2. Warm up the end of the tilt lever with a cigarette lighter for 1 minute.
  3. Push the knob into the lever, and use a rubber hammer (or regular but carefully if you don't have a rubber hammer) to gently tap the knob all the way in, until the knob is inserted all the way to the metal end.

Print settings:

  • Layer height: 0.2 (The model is 10.00mm in height, so 10.00 / 0.2 is exactly 50 layers)
  • Initial layer height: Also 0.2
  • Fan speed: 50% (The fan is needed mostly for the bridge above the port, but don't go too high and don't go too low)
  • Supports: No
  • Infill: 100% (Extra strength)

This was printed with an Ender 3 V2. The filament used is PETG from eSun. About 2 grams of filament was used, 24 minutes print time.

The model was designed in Tinkercad, the source can be found here: https://www.tinkercad.com/things/hOQqWBl8jfk

Tagi