Prusa MK3/S Einsy Ultimately ( REMAKE )

ITs FINALY HERE. 
My havy rebuild of Eisy Enclosure by KalleKnall. Its have several updates like a direct mount with Raspberry piW Zero2 to eisy bord. Check the UPDATE section for more info.

I noted that original did not have enough space and possibility to add more addons to. So redesign cover so you can get more stuff in to the box and same time it be more flexible for changes in the future. 
 

UPDATES

• Added Pin over the Rambo card so there are possible to get a cleaner cable mounting by using cable tie
• Added new  features so you can now add Raspberry PI Zero W2 directly to the Einsy bord. There are also outputs for both HDMI and USB C ports. also ability to connect Cam cable.
• The middle part have been change to add on plate that you can re design and change if you want to. i have added a blank plate and orginal plate. The blank plate you can download and change in a 3d application for your needs to add addons to. you easy replace the existent plate for  your own.
• Box Extender have allso been updated with a LM2596 DC-DC converter mount. also a plate that you can modify for your needs to add addons to. dor exempel arduino.
• Extender Box has also a hole for mounting the fan. Dimensions according to NF-A4x10
  It slitly tilted so it shuld puch air more into the box.

What you need

• Scruws = Comming soon
• Nuts = Comming soon
• Comming soon
• Comming soon

Importent Print instructions

FAN-covaver.stl is design that it get stack on the top and get fixed with Fan Scurvies from Nocta. If you print with Hatt-bigger-mod_With_cover you need support for the cover.
if you print Hatt-bigger-mod_without_cover you still need support under one cover frame.

Mounting Instructions.

When you mount Pi zero w2 and want to connect the USB c or HDMI 

The rest of the parts you can download from

Prusa MK3/S Einsy Raspberry PI 4B/3B Enclosure with support Brace
by KalleKnall

Remmember

This is testprinted from my end and mounted but …………………….

Warning

When all are mounted then move your Z axels manually up and down to be secure that it don't touch anything before you start printing. Its small tolerances on this setup and right steeper motor can touch the outstanding addon on the box.