1 / 5
Anycubic wash&Cure 2.0 Resin Vat Drainage Holder unfinished
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
model is an adapter to hold a resin drainholder for a anycubic wash and cure 2.0, that i never got to finish
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I designed this adapter/holder that you can add to the top of your Anycubic wash&cure 2.0.
Hardware and tools you need:
- 2* M5x30 SHCS or BHCS
- 4-6* M3x10-12 SHCS
- 4-6* M3 heatinserts short or long should work
- 4.2mm drill
- M5 tapping drill
How to set up:
- Take off the top plastic part
- drill out both exposed holes with the 4.3mm drill about 20mm deep
- tap some threads with the tapping drill (a bit less deep than the hole you drilled to prevent it from snapping)
- screw in the adapter part with your M5x30 screws
Vatholder:
- put your heatinserts into the back part
- screw in your vatmount with the M3 screws