1 / 2
SMA / RP-SMA connector Finger-Tightening Ring
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For easy tightening and release of SMA / RP-SMA -connectors from R/C equipment. Coupling torque values of 0.5 - 1.1 Nm…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 349
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
For easy tightening and release of SMA / RP-SMA -connectors from R/C equipment.
Coupling torque values of 0.5 - 1.1 Nm are recommended by the connector manufacturers.
I recommend printing at least four of these at the time.
- even with ABS continuous cooling was needed to prevent deforming
- 0.1mm clearance might be too much for PLA prints so there's another file with zero clearance
UPDATE: With Basjohan's remix you can also make a customized version.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.1 - 0.25 mm layer height
Infill:
30%
Notes:
Test printed with 0.25mm layer height, 0.4mm nozzle, 30% infill, PrimaABS.
Category: R/C Vehicles