Remixed - PwnCNC Dust Boot - Vinyl Cutter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed the PwnCNC Dust Shoe to hold Amazon Vinyl Cutter. If using the Makita router you'll also need this if you do…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 431
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed the PwnCNC Dust Shoe to hold Amazon Vinyl Cutter.
If using the Makita router you'll also need this if you do not already have it: https://cdn.thingiverse.com/assets/a7/76/bf/03/f6/Collar-65a.stl
This is the one I used from Amazon. https://www.amazon.com/gp/product/B0794T4Q9Y
I sourced a spring from my local Ace Hardware
I used M3 brass inserts and M3 bolts on the back just like you would for the dust shoe itself.
Printed upside down at layer height of .24 and 35% infull - full supports
Be careful not to forget the cutter is there and get your hand anywhere near it... sure not a table saw accident but they are sharp and does not take much to cut your hand up.
Print Settings
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: PolyMaker PLA
Category: 3D Printing