PC4-M8 PTFE Tube Fittingadapter for SOVOL SV06 PLUS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little adpater for SOVOL SV06 PLUS to use PTFE tubes directly to the extruder. Should work with normal SV06.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 148
- Wydruki
- 0
- Wyświetlenia
- 1278
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to use some PC4-M8 couplers that I bought for my mini+, so I could use the SOVOL SV06 PLUS with an MMU. This little print mounts on the heatbreak fan and on the two upper screws of the x carriage.
What you'll need
- I recommend it printing it with PETG
- 2x M2x8mm Screws
- 2x M2,5x8mm Screws
- 2x M3 Washers
- 1x PC4-M8 coupler
Print Settings
- 0.2mm Layereight
- 40% Infill (you probaly can use less)
- I used a Raft so it doesnt come loose
- I used organic supports
Installation
You will need to uninstall 4 screws from the extruder. Start with unscrewing the top two M2 screws from the Heatbreak cooler. Then unscrew the top two M3 screws which mount the extruder on the x axis carriage. Install the PC4-M8 coupler gently on the printed part. Dont over screw! For now yust lay the printed part on the extruder and look if it will fit. When it does, start with screwing in the M3 screws in the x carriage loosley. I used some washers, so the force of the screws spread evenly on the printed part. Now install the two M2 screws for the fan, again, dont use to much force. After that u can tighten the M3 screws completly.
Now you're done!
