Azodin KP3 regulator seat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement regulator seat for the KP3 (and similar) regs
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Replacement regulator seat for the KP3 (and similar) regs
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament: Ninjaflex TPU
Notes:
Original Ninjaflex has been tested. Also Prusaflex 98A. The 98A was more responsive, probably just because it is stiffer.
Installation: The old seat may not even be in the assembly anymore; they get shot out in pieces. I remove the o-ring and put the assembly in a vise, wrapped in a small sheet of brass to protect the threads. I then heat the top with a butane torch and work around the edges of the cap with a flat screwdriver. It lifts off slowly, just keep working around the edges. Once the cap is off, let it cool and clean out the pocket. The seat goes in easy; put the best side up. Replace the cap. I have a piece of leather that goes over the ends of the assembly, and I press the cap back on with the vise.
Category: Sport & Outdoors