Azodin KP3 regulator seat
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement regulator seat for the KP3 (and similar) regs
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 24
- Makes
- 0
- Views
- 201
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
Replacement regulator seat for the KP3 (and similar) regs
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament: Ninjaflex TPU
Notes:
Original Ninjaflex has been tested. Also Prusaflex 98A. The 98A was more responsive, probably just because it is stiffer.
Installation: The old seat may not even be in the assembly anymore; they get shot out in pieces. I remove the o-ring and put the assembly in a vise, wrapped in a small sheet of brass to protect the threads. I then heat the top with a butane torch and work around the edges of the cap with a flat screwdriver. It lifts off slowly, just keep working around the edges. Once the cap is off, let it cool and clean out the pocket. The seat goes in easy; put the best side up. Replace the cap. I have a piece of leather that goes over the ends of the assembly, and I press the cap back on with the vise.
Category: Sport & Outdoors