FT240 RFI Choke Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a nice FT240-31 choke box I use. It uses panel mount connectors as the rg58 I use cannot support the weight of…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 513
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a nice FT240-31 choke box I use.
It uses panel mount connectors as the rg58 I use cannot support the weight of the box, I have had 3 boxes where the ground broke loose from the connector so I went panel mount so I could use an rg8x jumper to my window panel and it holds up great, also it makes it great to go inline, a lot of antennas it is good to put the choke 25' away from the antenna in the feedline.
Mix 31 should be used for HF chokes.
See: https://palomar-engineers.com/ferrite-products/ferrite-cores/ferrite-mix-selection
I suggest you use chrome plated screws, I haven't had them rust yet but the black screws I have had rust in a month, after 6 months one was so bad I had to use pliers to unscrew it.
Infill doesn't matter as the walls are thin enough that infill shouldn't happen.
Category: Electronics