65mm "whoop" style quad case fits most 65mm quads UR65, M6, B65x, B65 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is a case I made a while back for 65mm quads, it fits the ur65, mobula6, beta65x, beta65 pro, pretty much all…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 316
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Here is a case I made a while back for 65mm quads, it fits the ur65, mobula6, beta65x, beta65 pro, pretty much all 65mm brushless quads.
v1 has a rounded bottom.
v2 has a bottom that is grooved to allow you to stack the lid under the bottom.
There are several height lids, the standard fits most quads but if you swap out for a circular polarized antenna you can print a taller top so it doesn't get squished.
support is needed for the bottom, infill doesn't really matter, I printed mine at 0.2mm layer height
Note: I do not make cases that hold batteries as well as I have too many quads that use the same batteries so I have a separate battery holder for the batteries. https://www.thingiverse.com/thing:3231043
Category: R/C Vehicles