M5 nut holder for 10 series t-slot aluminum extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed these for 10 series aluminum extrusions that are 1" x 1" square. key differences over others of the same,…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 103
- Wydruki
- 1
- Wyświetlenia
- 604
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I designed these for 10 series aluminum extrusions that are 1" x 1" square.
key differences over others of the same, the nut is twisted to grab mor metal when tightened, and the corners are rounded for easier printing.
Long version:
As most know t-nuts are expensive $9 US for 25 and then $15 shipping which is outrageous so I used M5 nuts and bolts, I probably should have tried M6 but I couldn't find any at the hardware store and didn't want to buy 200 of something that I had to grind the edges off, all I could get at the hardware stores was 1/4" (grind it), M8 (way to big) and #8 screws (too small) so I went with something that I knew would grab but didn't need to be ground but they are too small to touch the sides and so would spin and would flop around in the channel so I printed some holders for the nuts, there were quite a few out there already but they all have the flats of the nuts parallel to the flats of the channel and they don't overlap that much so I could see over tightening the screws and it pulling out of the channel so I made some that the nut is turned so that it grabs as much of the channel as possible, I also rounded the edges for several reasons:
- Printers move faster along curves than they do corners.
- When printers do corners they can leave extra plastic as it pauses at the corners (on mine anyways)
- When printing without fans (I was using ABS as I have lots of it) the corners of things angled up REALLY start to angle up and if it comes to a point it will cause a bulge up at every corner that needs to be cut off.
- Less plastic made them print faster.
Update 8/27/2015:
I needed some holders with the nut closer to the edge to get in close to the corner of a printer I am making, I shortened just one side of the holder and included it as well and it is also in the sketchup file.
Instructions
I printed them with ABS, not for any real reason other than I had a lot of out of spec ABS that I had unwittingly bought until I found a good brand.
0.4mm nozzle
0.2mm layer height
15% infill
240c hotend
110c bed
ABS juice to hold it down. ;-)
Category: 3D Printer Parts