Comic Book Separator & Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created new comic book separators that fit in every short and long box.
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 270
- Wydruki
- 1
- Wyświetlenia
- 2218
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was tired of the huge comic book separators that never fit in my short or long boxes. They were always too high and always did bend when the box was closed.
Another thing that bothered me was the unnecessary waste of plastic used for this separator. A huge piece of plastic of which I only needed the upper 5% to write down the comic series that's following it. Nothing more.
So I decided to print small separators that can be placed along the comics top border and that are not higher than the short/long box itself.
They fit perfectly on a backed & boarded comic issue. Even a supersize one without putting pressure on the cover. Just slip it over. You can also use it to go through your collection and place it where ever you want on your comic.
I hope you can make use of this.
Layer height: 0.24mm
Speed: 100mm
Infill: 15%
Time (depends on size): 19min.
PLA: 6g
Comic Stand
The second thing is a comic stand. I have boxes that are not full.
To keep the comics in place without falling is a pain for me. I have to lean them towards the back (risking to bend them) or lay them down in the box. So I designed a comic stand which you can clip on the side of your short box to keep your comics upright. You can use one of those clips but you will have a better stand if you use it on both sides.
If you don't need it, then just clip it somewhere on your box. Easy :)