1 / 5
Improvement of my Filament Spooler Machine — zdjęcie 1
1 / 5

Improvement of my Filament Spooler Machine

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The filament roll axle was not fixed in one position, thus it was sometimes hard to catch the corresponding drive gear.

Ocena
0 / 5
Polubienia
19
Pobrania
61
Wydruki
0
Wyświetlenia
1410
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The following two improvements refer to my earlier presented machine:

https://www.printables.com/de/model/351832-motorized-filament-spooler

The filament roll axle was not fixed in one position, thus it was sometimes hard to catch the corresponding drive gear.

So I created a new receiver for the axle to have a fixed position instead of sliding right to left. The provide this there are two additional distancers, which can be slided in and out. Once slided in, they can stay there for lifetime. Alternatively you can also use washers Ø10mmx2mm or adequate), but this requires to disassemble the filament-roll holder. You may change the thickness of the distancers to your situation. I had 2.6mm each.

The new fixed position receiver has improved grooves to cat the righ position earlier.

Next step would be to use a stronger motor (most likely a stepper motor with filament guide which will be adjustable and run in Master-Slave mode, if this is possible. Controlled by an Arduino MicroController. This may take me some time, but it is on the plan! Maybe somebody of you can give me help, and we can develop this together? Let me know!

Explore my other Printables: https://www.printables.com/de/@Tritschi 

Tagi