Improvement of my Filament Spooler Machine
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The filament roll axle was not fixed in one position, thus it was sometimes hard to catch the corresponding drive gear.
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 62
- Makes
- 0
- Views
- 1,411
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The following two improvements refer to my earlier presented machine:
https://www.printables.com/de/model/351832-motorized-filament-spooler
The filament roll axle was not fixed in one position, thus it was sometimes hard to catch the corresponding drive gear.
So I created a new receiver for the axle to have a fixed position instead of sliding right to left. The provide this there are two additional distancers, which can be slided in and out. Once slided in, they can stay there for lifetime. Alternatively you can also use washers Ø10mmx2mm or adequate), but this requires to disassemble the filament-roll holder. You may change the thickness of the distancers to your situation. I had 2.6mm each.
The new fixed position receiver has improved grooves to cat the righ position earlier.
Next step would be to use a stronger motor (most likely a stepper motor with filament guide which will be adjustable and run in Master-Slave mode, if this is possible. Controlled by an Arduino MicroController. This may take me some time, but it is on the plan! Maybe somebody of you can give me help, and we can develop this together? Let me know!
Explore my other Printables: https://www.printables.com/de/@Tritschi