1 / 1
Prusa Mendel i2.5 X-axis Idler and Motor Ends — zdjęcie 1

Prusa Mendel i2.5 X-axis Idler and Motor Ends

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I'm upgrading an old Mendel i2 to something closer to an i3. We'll call it i2.5

Ocena
0 / 5
Polubienia
0
Pobrania
23
Wydruki
0
Wyświetlenia
190
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Inspired by current i2/i3 x Driver and Idler designs. Hacked together crudely with apologies to the precision work by the Prusa team ;) We can only afford precision guesswork here.


Important Notes:

  • Spacing between Z-axis guide rod and screw is different from modern designs. This is for the old Mendel design (https://reprap.org/wiki/Prusa_Mendel)  with spacing of 30mm (wider than modern design)
  • Idler and motor side Z-axis guides have cutouts sized for LME8UU (European) ID8, OD16, L25 linear bearings … but should be workable for US LM8UU - probably, holes will be oversized. See https://reprap.org/wiki/Linear_bearing
  • x-axis guide rod spacing should be the same as modern i3 design - 45mm
  • T8 lead screw used for z-axis, note 3.5x mounting holes per side
  • Idler end just has a plain thru hole for M8 rod

Use case:

Tagi