1 / 20
Suction hood for Stepcraft 2/600 mill with Kress 800kfme — zdjęcie 1
1 / 20

Suction hood for Stepcraft 2/600 mill with Kress 800kfme

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a suction hood for my Stepcraft 2/600 mill with a Kress 800kfme. The design is for a 25mm suction hose. The…

Ocena
0 / 5
Polubienia
1
Pobrania
23
Wydruki
0
Wyświetlenia
283
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a suction hood for my Stepcraft 2/600 mill with a Kress 800kfme.

The design is for a 25mm suction hose.

The orange plate is the Stepcraft plate holding the mill. This doesn't need to be printed ;)

You will need

  • a 25mm suction hose of course.
  • 1x M5x30mm
  • 1x M5 Nut
  • 16x Neodym magnets 3x5mm (height x diameter)

Update 08.01.2017:


===========================

  • Added a suction shoe which can be mounted on top of the "Saugstutzen" in order to make a suction funnel for manual working with the suction.

Update 05.09.2016:



  • CorrectedI the wrong place for the pin of Oberteil_V2 which is going into the plate of the mill.
  • Modified the brush part in order to be able to use a strip brush (I was defenitely not good in glueing in the brush)
  • Added a clamping part for the strip brush. This part is very tight in order to hold the brush in place. I ordered this brush: http://www.enobi.de/waermedaemmung/buerstendichtung/mi0003 With 30mm brush hairs.

I also added some holder for the cable of the KRESS mill to the suction hose (mine is ID/OD 25/28mm) and also holders for the 40mm tubes which are installed in my housing.

Print Settings

Printer:

CTC Dual

Rafts:

No

Supports:

Yes

Resolution:

0,2

Infill:

20%


Notes:

It should be easy printable.
Support is only needed in part Oberteil\_V2 for the bolt head.

I printed this in PLA Orange now as the colour fits better to the Stepcraft.

This can be printed from all materials.

How I Designed This

Designed with solid works

Category: Hobby

Tagi