Arducam Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the Arducam OV5647
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 1
- Wyświetlenia
- 584
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I tried the original model, but the case was larger than the model of Arducam that I had, and I didn't have any spare M2 bolts on hand.
So I remodeled the case to fit the smaller model Arducam OV5647 (the one without a lens). This is the camera I used.
This case is designed to fit on to the arm from the original (CameraArm.stl here), so I didn't include that model, as I hadn't changed it.
Uses four M3 bolts to secure the two pieces together. The bolts are a pretty tight fit, so they might be problematic if your printer tolerance is a bit loose.
There's also small extrusions that are intended to clamp the PCB in place when it's fully closed. Don't over-tighten the screws or you may damage the PCB.