Eibos Easdry Filament PTFE Tube PC4-M10 Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Press fit connector for the Eibos Easdry filament dryer. Presses directly into the existing rubber grommet on the dryer.
- Ocena
- 5 / 5
- Polubienia
- 66
- Pobrania
- 388
- Wydruki
- 9
- Wyświetlenia
- 2045
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Press fit PTFE tube connector for the Eibos Easdry filament dryer. The barbed end press fits directly into the rubber grommet in the housing of the dryer. The threaded side accepts a PC4-M10 fitting to connect PTFE tubing.
I printed in PETG on a Bambu Lab P1P, 0.8mm layer height. I placed the larger diameter side face down with support inside the threaded opening. 0.25mm top Z distance, 0.5mm support/object XY distance, and 1mm base pattern spacing with standard support.
The inside top opening of the cylinder needed a little cleanup/reaming with an Xacto after removing supports but the threads came out perfect. The fitting threaded in easily by hand. I used a bit of a swirling motion when installing onto the dryer to get it into the rubber grommet and make sure it didn't push it through the opening.
I was concerned initially about how thin the barbed tube is coming out the top, but it feels pretty solid and should be robust inside of the rubber grommet once installed. Quick and easy to reprint if it does break at some point down the line.
Fittings I used are PC4-M10 from Amazon: https://a.co/d/bmIbpSh