Folger Tech FT-5 170mm Alignment Tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a tool for building the Folger Tech FT-5. It calls out to space the two upper levels 170mm apart. Had no way…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 97
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a tool for building the Folger Tech FT-5. It calls out to space the two upper levels 170mm apart. Had no way of doing it. My dial calipers only went to 6" or a little over 152 mm so I just made my own tool to do the job. Nice to have a 2nd 3D printer handy!! I used Tinkercad. This is my first time using it. It only took about 20 minutes to design.
Note: I had them measured and off of my Rostock they came out 173.23 mm. Should be close enough to work. I will be fixing the length problem and uploading it in a few days.
I fixed the STL! It was Tinkercad that didn't keep the 170mm dimension. I used 123D Design to tweak it in tolerance. Also made the STL 'Fine' when I saved it so it looks better. Maybe...
One more thing. Print 2. It works better that way.
Print Settings
Printer Brand:
SeeMeCNC
Printer:
Rafts:
No
Supports:
No
Resolution:
.30
Infill:
20
Category: 3D Printers