SCALEPRINT RD-11 STONE DORMER FOR 45 DEGREE ROOF 00/HO SCALE
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hello all Still into the archives and still in the area of roofs. This thing is for a dormer for a 45 degree roof, and…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 324
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Architecture & Urbanism
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello all
Still into the archives and still in the area of roofs. This thing is for a dormer for a 45 degree roof, and for a building made from stone. There are 2 roof patterns the one that is shown in the photos and a second one that is called Victorian.
The brick 45 degree and the 60 degree roof style will follow
Print Settings
Printer:
ORDBOT HADRON
Resolution:
0.2 NOZZLE .1 LAYER HEIGHT
Notes:
Being as I am so that the surface of the roof tiles was parallel to the X/Y axis's I printed them with the bed at about a 7 degree angle,( photo below ) to give a flat not a stepped surface as would normally be printed when the top surface is at an angle.
Most people cannot do this so printing on a normal bed you will have to clean the top surface of the roofs.
Or you could put the roof tiles at an angle so the tile surface is in line with the X/Y axis's
Post-Printing
BED AT 7 DEGREES FOR PRINTING ROOF
Category: Buildings & Structures