1 / 4
SOUTH BEND LATHE MODEL 9C ( 1937-1940 ) HALF  NUTS CAM LEVER — zdjęcie 1
1 / 4

SOUTH BEND LATHE MODEL 9C ( 1937-1940 ) HALF NUTS CAM LEVER

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a replacement part for a South bend lathe model 9C that I just received, this part was missing so made a…

Ocena
0 / 5
Polubienia
2
Pobrania
28
Wydruki
0
Wyświetlenia
334
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a replacement part for a South bend lathe model 9C that I just received, this part was missing so made a replacement out of ABS PLA may be stronger.

I made it in 2 halves and glued them together with ABS juice.

The photo's are some I found on the net, as I did not have one to copy.

Works fine as there is not much load on the lever.

I will have other pieces for this same lathe, change gears, cross slide nut, top slide handle,

Plus whatever I need to replace because it is missing or worn out.

My lathe was made between 1937 and 1940.

Post-Printing

clean up

Depending on your printer will need minimal clean up on the dia that fits into the hole in the apron

Category: Parts

Tagi