USB insert for 2006 Subaru WRX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert for female USB leads to go into one of the empty control spaces in a 2006 Subaru Impreza WRX. The gap in the…
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 703
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
An insert for female USB leads to go into one of the empty control spaces in a 2006 Subaru Impreza WRX. The gap in the middle should be enough for two female leads to fit snugly.
This was created to set up a tidier way of containing the leads from an Atoto A6, rather than just having them hang down under the centre console.
It should fit the base Impreza as well, but I don't believe the STI has the required empty control space (you get fun stuff like diff lock controls instead).
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
.16mm to 23mm height, .08mm above that
Infill:
30% (probably overkill)
Filament:
Rigidink PLA
Notes:
I set the layer height to .08mm from 23mm high, just to make sure the slight curve on the top of the insert was as smooth as possible. .16mm/layer below that, so it didn't take forever.
I printed it in the orientation it is, letting Simplify3D automatically set supports.Category: Automotive