1 / 3
B.C Rich Warlock Guitar Body Remix for Tune o Matic Bridge — zdjęcie 1
1 / 3

B.C Rich Warlock Guitar Body Remix for Tune o Matic Bridge

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of the Rich Warlock guitar body with a few changes to the middle pieces for my preferences.

Ocena
0 / 5
Polubienia
85
Pobrania
571
Wydruki
1
Wyświetlenia
4629
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

All of the changes are made are only to the middle two pieces, so those are the only models I included here. If you would like to print this guitar, grab my two files and then get the rest from the original model. I am very much a beginner in using Fusion 360 so the models are most likely not made in the most optimal way.

 

Here are the changes I made to the middle pieces:

  • Filled in bottom cavity meant for the Floyd Rose bridge and springs and the space meant for the metal plate.
  • Created a 10mm hole through both pieces to allow a carbon fiber rod to join the two pieces to add extra rigidity.
  • Adjusted and added holes at the top of the middle bottom piece to allow for the tune o matic bridge to be set properly.

 

Here is a link to the carbon fiber rod and bridge that I bought:

No special instructions are needed to print these pieces so just follow the original post for printing and assembly. 

When adjusting the model I forgot to measure for my neck's scale length (Distance between nut and 12th fret = Distance between 12th fret and bridge). Mine is a bit off so it might be worth double checking and moving the holes for the bridge a bit back.

The only thing to note is the holes for the bridge posts are slightly smaller than the actual posts. I did this so that I can install the posts by heating it up with a soldering iron and melting it into place.

 

Tagi