1 / 3
Teeho Fingerprint Electronic lock Extender/Adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My door's lock hole is a little too small but I didn't want to cut a new one. This adapter works with any size door hole
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This allows you to use a smaller hole in your door than the one required by Teeho. This adapter plate slips between the outside keypad and the door. It will fit snug with no adjustments needed. You will also need to print the adapter piece for the inside metal piece to connect and be able to turn. I used PLA+ but I'm sure PETG would be great too.
Keypad:
- Black PLA+
- .2 Standard Layer Height
- 2-3 walls
- 30% Cubic Infill
Slot Adapter:
- Black PLA+ (It has held up so far, if it breaks I will replace with PETG)
- .16 Dynamic Layer Height
- 5 walls
- 100% zig-zag infill
- Print on its side for strength
- Use a support blocker for the inside otherwise it might be tough to remove
- Standard support for the skinny part