1 / 1
Ender 6 PEI Bed Guide
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A PEI build plate guide to make aligning the PEI sheet easier this screws into the Z axis arms.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 149
- Wydruki
- 3
- Wyświetlenia
- 1533
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 3) (Komentarze: 5)Remiksy (1)Kolekcje (40)Powiązane
Tried to use the original that this was remixed from but as I'm using silicone spacers it sat higher than my bed. I also made sure to leave some clearance for the internal spool holder mod that I'm running.
This attaches to the arms for the Z axis rather than the cross bar.
One of them has a cut-out for the the Heated Bed cables.
I used an M3x16mm screw with a T-Nut for each one.
As it is close to the bed I'd recommend printing in ABS.
I use a 0.6mm nozzle and printed with a 0.3mm layer height.
