Onexplayer 2 Case - Tablet Mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Encases your OXP2 in a case with a slot that holds the keyboard closed and turn it into a tablet.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 133
- Wydruki
- 0
- Wyświetlenia
- 1041
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for the OXP2. The device slides freely from the side but it does have a keyboard cutout for the magnetic keyboard that keeps the device secure. This is to keep the controller rails fully exposed so they can still be used with the case on.
You'll need the keyboard or controllers to keep the device secure.
All other IO is cut out, same with the kickstand, which is still functional.
I printed this with TPU, but it does work with PLA. I just imagine the actual protection is limited due to PLA being more of a rigid material. It should still prevent from scratches though!
Be warned, this is a hard print due to the amount of supports needed.
The thin sides are going to be a challenge to remove the supports from without breaking.
- Supports - Yes
- (For TPU only)
- Top interface layers - 3
- Infill
- 20%
- Cubic