CLIPPER Lighter Sleeve Vase Mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CLIPPER Sleeve that prints fast in Vase Mode
- Ocena
- 4,2 / 5
- Polubienia
- 87
- Pobrania
- 494
- Wydruki
- 7
- Wyświetlenia
- 1546
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Inspired by darknrg's Clipper Lighter Case design, I based my model roughly on his dimensions. However I wanted the model to be a little bit more snug, especially in the top area, so I re-sketched the model and changed some angles a bit and reduced the top gap by 1 mm.
For this to work use vase mode with the standard parameter for the outer wall which was 0.42mm in my case. The bottom base is 1.2mm thick so best use 0.2mm layer height with 6 bottom layers. This will create a Clipper sleeve with a kind of see through effect, which looks very nice in my taste.
Depending on your printer this is a very fast print, since it is a rather small sleeve in vase mode.
Happy printing.