1 / 7
Standvorrichtung SYMFONISK Tischleuchte WiFi-Speaker / Stand device SYMFONISK Speaker lamp — zdjęcie 1
1 / 7

Standvorrichtung SYMFONISK Tischleuchte WiFi-Speaker / Stand device SYMFONISK Speaker lamp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Standvorrichtung für SYMFONISK Tischleuchte WiFi-Speaker / Stand device for SYMFONISK Speaker lamp w Wi-Fi;

Ocena
0 / 5
Polubienia
5
Pobrania
33
Wydruki
0
Wyświetlenia
535
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

English below

Standvorrichtung für SYMFONISK Tischleuchte WiFi-Speaker, Ober- und Mittelteil können aus PLA oder anderem Material gedruckt werden. Ich habe mich für das GreenTec Pro von Extrudr entschieden. Die Füße sind aus TPU gedruckt, müssten aber auch aus PLA funktionieren. Die Stangen sind aus Alu-Rohre mit 12mm Durchmesser - im Baumarkt erhältlich. Ich habe mich für eine Länge von 800mm der Stangen entschieden. Stangen erst durch den Mittelteil führen, in der Höhe ausrichten, damit das Oberteil drauf passt - ca. 380 bis 400mm von Unterkante Oberteil bis Oberkante Mittelteil. In das Oberteil habe ich einen Moosgummi geklebt, ist aber nicht unbedingt erforderlich, da die Lampe/Lautsprecher Gummifüßchen haben.

Durch die drei Füße und den Alustangen steht der ganze Ständer sehr stabil und ich bin zufrieden.

Durchmesser Oberteil: 182mm

Durchmesser Mittelteil: 236mm

 

English:

Stand for SYMFONISK table lamp WiFi speaker, upper and middle part can be printed from PLA or other material. I chose the Extrudr GreenTec Pro. The feet are printed out of TPU, but should also work out of PLA. The rods are made of aluminum tubes with a diameter of 12mm - available in hardware stores. I decided on a length of 800mm for the rods. First guide the rods through the middle part, adjust the height so that the upper part fits on it - approx. 380 to 400mm from the lower edge of the upper part to the upper edge of the middle part. I glued foam rubber into the upper part, but it's not absolutely necessary because the lamp/speakers have rubber feet.

Thanks to the three feet and the aluminum rods, the whole stand is very stable and I am satisfied.

Diameter upper part: 182mm

Diameter middle part: 236mm

Tagi