Dstike PacketMonitor32 case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This was designed as a housing for the packet monitor 32 from DSTIKE.https://github.com/spacehuhn/PacketMonitor32 I…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This was designed as a housing for the packet monitor 32 from DSTIKE. https://github.com/spacehuhn/PacketMonitor32
I got the board on Tindie if you stumbled across this, it is a fun little toy.
Other parts:
Battery[ https://www.amazon.com/uxcell-1300mAh-Rechargeable-Lithium-Polymer/dp/B0767K9SSV/ref=pd_ybh_a_36]
[1300mAh 3.7vdc]
JST connectors at 2mm pin pitch
SPST slide switch with body of 5mm x 10mm
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
20%
Filament: CubeFila PLA 1.75 green Post-Printing =============
Assembly
To use this case with a battery as illustrated you need to remove the existing battery connector and solder in a pigtail female connector. (otherwise the housing blocks the battery connection. To add in the switch (body of the slide switch I used is 5mm x 10mm), either use additional connectors as it is in the pictures or splice the switch into the lead on the board itself. You can then secure the switch into the housing with just pressure or add some security by adding a bit of CA glue or hotmelt glue. Using 2 socket head screws (m2.5) secure the 2 halves.
Category: 3D Printer Parts