Stand for Chompi

This is a stand for the Chompi Chromatic Sampler and Tape Music Instrument. It raises the Chompi up by 1.5 inches and gives it a comfortable angle. It includes large wire channels to make it easy to route the audio and power cables.

NOTE:
> Print in your favorite filament (Tough PLA recommended)
> 10% infill, 5 walls, Honeycomb pattern
> Print with supports ("On built plate only" for the wire channels only)
> Add 6 X 3M / Scotch Bumpon medium sized rubber feet (optional, not needed)
> IF you would like a heavier stand, you have 3 options:
1 - Change the infill to a higher value (e.g. ~50%).
2 -  “Add a modifier” to the first 0.5 - 1 inch and change the infill of that area to ~80% infill. 
3 - You can also pause the print at 1 inch and carefully add dry sand to the long Honeycomb channels being formed inside the structure…

>If you would like to have an anti-slip mat for your Chompi to be used with this stand or used standalone, You can print this mat out of TPU:
https://www.printables.com/model/486042-anti-slip-mat-for-stand-for-chompi

* If you like my models, please consider donating the small amount of $1 to help me with development and design… (via: Ko-Fi ) - Thank You!