Toyota Radiator Support Splash Shield Grommet 52116-0C090
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are the plastic inserts that retain the screws used on the front of the skid plate on Toyota Tundra and Sequoia.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 418
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Tundra and Sequoia owners who have had their front skid plates on/off multiple times (e.g. each oil change) will eventually experience the failure of Toyota Part #52116-0C090 due to over tightening or material brittleness etc. This 3D model is a drop in replacement for the original Toyota Part #52116-0C090. The worn out original part will easily pop out of the metal skid plate holes and these will pop right in to the same original square holes. This is a fast, easy, inexpensive and simple part that you can keep in your toolbox or glove box in the likely event that one get damaged (likely from an inexperience, overzealous mechanic wielding a 20V impact driver on power level 3). The square hole in the skid plate that these fit into is approximately 11mm x 9mm. I have sized the fastener hole at 5.25mm so it is snug, but not too snug. This part is not structural nor load-bearing. There is a 65° overhang angle designed into the part under the flange to help it print properly. I printed mine with the round boss facing down towards the build plate. Please select the appropriate filament type for your application. (I used a high-temperature nylon filament on mine, however YMMV.) Cheers!
If you feel so inclined, you can buy me a coffee:
https://bmc.link/DKonneker