Toyota Radiator Support Splash Shield Grommet 52116-0C090
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are the plastic inserts that retain the screws used on the front of the skid plate on Toyota Tundra and Sequoia.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 50
- Makes
- 0
- Views
- 418
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
Tundra and Sequoia owners who have had their front skid plates on/off multiple times (e.g. each oil change) will eventually experience the failure of Toyota Part #52116-0C090 due to over tightening or material brittleness etc. This 3D model is a drop in replacement for the original Toyota Part #52116-0C090. The worn out original part will easily pop out of the metal skid plate holes and these will pop right in to the same original square holes. This is a fast, easy, inexpensive and simple part that you can keep in your toolbox or glove box in the likely event that one get damaged (likely from an inexperience, overzealous mechanic wielding a 20V impact driver on power level 3). The square hole in the skid plate that these fit into is approximately 11mm x 9mm. I have sized the fastener hole at 5.25mm so it is snug, but not too snug. This part is not structural nor load-bearing. There is a 65° overhang angle designed into the part under the flange to help it print properly. I printed mine with the round boss facing down towards the build plate. Please select the appropriate filament type for your application. (I used a high-temperature nylon filament on mine, however YMMV.) Cheers!
If you feel so inclined, you can buy me a coffee:
https://bmc.link/DKonneker