Whiteboard Marker Magnet Holder (STAEDTLER)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple magnet holder for Whiteboard Marker (STAEDTLER) Using two 10x2.2 mm magnets.
- Ocena
- 4 / 5
- Polubienia
- 11
- Pobrania
- 59
- Wydruki
- 1
- Wyświetlenia
- 330
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this holder to have a simple and low profile magnetic holder for my whiteboard markers.
It holds on to the cap, so your hands are cap-free while writing.
Settings:
- PLA+
- 0.6mm nozzle
- 0.6mm extrusion width
- 0.2mm layer height
- 3 Shells
- No suppports (bridging works fine)
- 25% infill (doesn't matter)
- skirt
Slicer tweaks:
To optimize the ugly layer mark that most people have when pausing mid-print.
(Occurs due to outer Shell not being printed completely.)
- Deactivated: “Force Retraction when moving to outer shell”
- changed the printing order to: Infill→InnerShell→OuterShell
Another (easier) option that also works would be to print multiple holders at the same time, so just one has the ugly layer mark.
Installing the magnets during print:
- You need two 10x2.2 mm magnets
- I stopped at 3.02mm (in my case layer 15) and inserted the magnets.
- Then I completed the print
- One holder prints in 16 minutes and uses 2.7g of filament
Installing the holder after print:
- Its a pretty snug fit onto the cap of the marker. (you might as well need a hammer for the last 2mm)
- no wiggle room, i love it!
Also check out my homepage at: hellgineer.com