1 / 3
Gaggiuino 2.4, 2.8, 3.5, and 4.3 inch Nextion Display Housings — zdjęcie 1
1 / 3

Gaggiuino 2.4, 2.8, 3.5, and 4.3 inch Nextion Display Housings

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For use with Nextion display on Gaggia Classic Pro.

Ocena
5 / 5
Polubienia
34
Pobrania
559
Wydruki
3
Wyświetlenia
5055
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

Fork of project site:

Open-Espresso/gaggiuino-builders: A Gaggia Classic control project using microcontrollers. (github.com)

Discuss:

Gaggiuino Builders | Facebook


You can buy these printed here at www.matter-replicator.com

 

For use with Nextion display on Gaggia Classic Pro. Run the wires through the steamer hole. Use two 60x10x3mm magnets.

PLA is ok for the normal ones, but higher-temp material is best for the 4.3"


Get a build kit here: Build kit for V3 PCB – Matter-Replicator

Get a PCB here: V3 PCB – Matter-Replicator
 

The Gaggiuino© logo and name is © Zer0-bit. I am not affiliated with the creators of the project.
 
Note: The 3.5 inch LCD file was created by Steve Nofs

Note: This display is upside down from the normal build so that the wire can be near the steamer hole, so you will need to use the Nextion Editor to change the display to 270 degrees.


FINDMAG 6 Pack Powerful Neodymium Bar Magnets Rare Earth Magnet Bar, Strong Bar Magnets Neodymium Magnets with Double Sided Adhesive - 60 x 10 x 3 mm: Amazon.com: Industrial & Scientific

 The 4.3 inch one also can use these magnets at the top, which seem important for stainless models:

https://www.amazon.com/gp/product/B0BTSWCCXG/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

Tagi