1 / 3
Gaggiuino 2.4, 2.8, 3.5, and 4.3 inch Nextion Display Housings — image 1
1 / 3

Gaggiuino 2.4, 2.8, 3.5, and 4.3 inch Nextion Display Housings

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For use with Nextion display on Gaggia Classic Pro.

Rating
5 / 5
Likes
34
Downloads
559
Makes
3
Views
5,057
Reviews
3

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial

Fork of project site:

Open-Espresso/gaggiuino-builders: A Gaggia Classic control project using microcontrollers. (github.com)

Discuss:

Gaggiuino Builders | Facebook


You can buy these printed here at www.matter-replicator.com

 

For use with Nextion display on Gaggia Classic Pro. Run the wires through the steamer hole. Use two 60x10x3mm magnets.

PLA is ok for the normal ones, but higher-temp material is best for the 4.3"


Get a build kit here: Build kit for V3 PCB – Matter-Replicator

Get a PCB here: V3 PCB – Matter-Replicator
 

The Gaggiuino© logo and name is © Zer0-bit. I am not affiliated with the creators of the project.
 
Note: The 3.5 inch LCD file was created by Steve Nofs

Note: This display is upside down from the normal build so that the wire can be near the steamer hole, so you will need to use the Nextion Editor to change the display to 270 degrees.


FINDMAG 6 Pack Powerful Neodymium Bar Magnets Rare Earth Magnet Bar, Strong Bar Magnets Neodymium Magnets with Double Sided Adhesive - 60 x 10 x 3 mm: Amazon.com: Industrial & Scientific

 The 4.3 inch one also can use these magnets at the top, which seem important for stainless models:

https://www.amazon.com/gp/product/B0BTSWCCXG/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

Tags