1 / 2
Slip in Door Hinge Shim - 3-1/2" Radius Corner - 3 Screw Hinges — zdjęcie 1
1 / 2

Slip in Door Hinge Shim - 3-1/2" Radius Corner - 3 Screw Hinges

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Have an annoying sticking door and need to shim the hinges. This design will make shimming a breeze

Ocena
5 / 5
Polubienia
24
Pobrania
269
Wydruki
1
Wyświetlenia
701
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a simple slip in door hinge shim. This shim is designed around a standard 3-½" radiused corner door hinge.  The screw holes are slotted so the shim can be slipped in and tested without fully removing the hinge screws. The shim will be visible if installed on the door side of the hinge, but will essentially disappear if slipped in between then jamb and the hinge.

As modeled and printed at a 100% scale, the shim should be 0.050" thick.  To change thickness, unlock the scale factor by clicking on the grey lock button.  This will allow you to change the scale in one axis while leaving the other dimensions alone.  At this point you can linearly scale the Z axis value to achieve any range of thicknesses you need. Every 10% up or down in scale will change the thickness by 0.005" (.127mm)

Z Axis ScaleShim Thickness (Inches)Shim Thickness (mm)
1000.0501.27
500.0250.635
1500.0751.905

Tagi