Magnetic dishtowel holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for dish towel in sink. Uses magnets for mounting.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
To store our dishcloth better than hanging it over the faucet, i designed this holder.
You need a 6mm thick rod to put it between the printed parts. I used anodized aluminum tube.
During printing you have to pause at the right height to insert a 10x10x10mm magnet. This will then be completely enclosed by the print. Here you have to be a little careful that the magnet does not tear the print from the plate when it is attracted by the print bed.
The second print part must be mirrored once in the slicer.
In total, you need four magnets: two go into the two print parts and two on the outside of the sink.