Back Blade - OpenRC Tractor MK3 TEA20
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little something to push dirt and/or snow around with.
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 305
- Wydruki
- 2
- Wyświetlenia
- 1418
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple little print. All the hardware is 3mm (if you've built the tractor no doubt you have enough hardware left over)
The blade can be set to push or pull and also locked in at an angle left or right depending on the need.
While it's not accurate to any real world implement it is modeled on all of them, and I think the proportions are close enough for the OpenRC MK3.
When I designed it I had thought to put a 3mm rod through the bottom of the hitch part. That is why the hole goes all the way through. I found that just pushing a couple of cap screw from either side keeps it attached to the tractor just fine.
It is quite fun to play with.